Page 1 of 1
Posted: Thu Oct 07, 2004 11:17 am
by stranj
lo there. anyone know where i can get the docs for ballistic? the dl page at flip doesent seem to be working
Posted: Thu Oct 07, 2004 12:09 pm
by Graydon
Oh it's working just fine... they just dont have any docs yet. a good 2 or 3 months after release and they have no docs. Shows you the abilities of Blades eh? 
What I suggest you do though is go into FF forums.. a bunch of sticky posts have tutorials on certain aspects of M3 mapping.. might be able to scrounge some information from there.
And just as a side note (and not to discourage you or anything) but this forum is _not_ connected with FlyingFlip.. so isnt necessarily the best place to come for information on them... you might get a uh.. biased... answer.
Good luck!
Posted: Thu Oct 07, 2004 6:51 pm
by lank
to be fair, gray, docs can and often do take a long time to write and check.
that said, i honestly have no clue what, if anything, is going on behinds the scenes at FF. i would presume, however, that they're working to some kind of internal schedule.
Posted: Fri Oct 08, 2004 10:49 am
by Graydon
Oh i know lank... wasn't really trying to slag them.. I know Maug is working on a similar type document for modeling... these things take time. But from the times i've dropped by and asked about things like that document.. all i get in reply is 'look in the forums.. lots of information in sticky posts'. Same thing.. over and over.. 
No work is being made on those docs.. they're slaving away at a linux port of M3 now i believe... not even LoD
Meh.. it will come ..then we can judge the hell out of it!